18-05-2012, 05:52 PM
Right good bit of progress this evening.
Finished honing the bores
![[Image: 5ad4417b.jpg]](http://i290.photobucket.com/albums/ll257/niallharper/5ad4417b.jpg)
Got the remaining pistons in with my shiny new compressor that will now not get used again!
![[Image: 55108ac9.jpg]](http://i290.photobucket.com/albums/ll257/niallharper/55108ac9.jpg)
(that looks timed up correctly yeah?)
Got them all in, new shells in and torqued up. Oil pump went back on and the sump had a bloody good clean (it's been leaking since I've had it so there was years of oil and crud on there!
Also got the air con compressor back on, modified my matrix hose so it didn't have a kink In it and cleaned up the block face ready for the new gasket and head.
Hopefully get the head back on tomorrow morning before I go out then finish it sunday!
Finished honing the bores
Got the remaining pistons in with my shiny new compressor that will now not get used again!
(that looks timed up correctly yeah?)
Got them all in, new shells in and torqued up. Oil pump went back on and the sump had a bloody good clean (it's been leaking since I've had it so there was years of oil and crud on there!
Also got the air con compressor back on, modified my matrix hose so it didn't have a kink In it and cleaned up the block face ready for the new gasket and head.
Hopefully get the head back on tomorrow morning before I go out then finish it sunday!
Team Eaton
1999 China Blue 306 GTi6 - Eaton Supercharged - 214.5bhp 181lbft
1999 China Blue 306 GTi6 - Eaton Supercharged - 214.5bhp 181lbft