rear torsion bar removal

[mark_airey]

Not the stud, but the collar that the 8mm hole is in screws out of the arm, or would do if it wasn't seized in.

I'm checking with pug now to see how readily available the collars and studs are before i take it apart again and smashing the torsion bar through via the stud and have to replace them.

20-30mm on the splines? I must have been lucky, as had no problems getting the bars back in. I adjusted it twice and didn't have to fiddle about up and down.

the torsion bar screws like this you mean.............


Are you sure the bit with the hole in unscrews? I'm pretty sure its part of the arm but I might be wrong