Hunter the B-road sigma..

[ginge191]

Ok, so sorted the exhaust out - it is now EMPTY, and quite interesting to see what was inside, i never knew!

So, Step 1, put exhaust into a HUGE saw...



Step 2, cut into another 3rd, going around you're brackets..



Step 3, realise that it's deeper than a small angle grinder, so get a bigger one..



Step 4, hammer out and admire the insides, chuck away....



Step 5, Weld back together, grind down, check for leaks, weld again.. done!



when i put it on the car, i'll chuck some firegum around the welds, obviously not on the car yet due to stuuupid weather!