01-02-2018, 10:02 AM
(This post was last modified: 01-02-2018, 10:57 AM by pug306driver.)
Don't know if these will help, cant remember where I got these from, similar info in guides section. For sensors, check resistance when cold ( when they are behaving ) and check again when hot ( when the car misbehaves ) and compare, also signal output.#
ok bosch publications too large to post.
do these open, anyone ??
ok, bosch fuel injection manual for.......
Bosch Fuel Injection System ( AIRD )
HP Books. Bosch d, l and LH jetronic, LH Motronic, K and KE jetronic.
Bosch Automotive Handbook 1st Edition 2002 17mb
bosch handbook 2002, loads of tech info but not resistance value for the almera bosch diesel fuel inj pump !!!!! still going round in circles with that one, but suspect spill solenoid burn out due to really low ohms value, 0.4 ohms.
Cant get that bugger out without wrecking the dam thing, but have not tried "pressure " yet, to blow the dam thing out.
Can e mail them to admin to add to this site ??
ok bosch publications too large to post.
do these open, anyone ??
ok, bosch fuel injection manual for.......
Bosch Fuel Injection System ( AIRD )
HP Books. Bosch d, l and LH jetronic, LH Motronic, K and KE jetronic.
Bosch Automotive Handbook 1st Edition 2002 17mb
bosch handbook 2002, loads of tech info but not resistance value for the almera bosch diesel fuel inj pump !!!!! still going round in circles with that one, but suspect spill solenoid burn out due to really low ohms value, 0.4 ohms.
Cant get that bugger out without wrecking the dam thing, but have not tried "pressure " yet, to blow the dam thing out.
Can e mail them to admin to add to this site ??