19-01-2017, 08:59 PM
Pictures will follow.. for a HDi
this is for the following:
Oil lines and drain
turbo (unsure of condition, however these are dirt cheap and it was boosting well till the car got written off and will check before postage)
exhaust manifold
Subframe, with modified bespoke solid gear linkages and main gear linkage arm thingy (that goes between the stick and linkages)
Downpipe with flexi to weld onto mid section (this will need at LEAST a 2.25inch pipe to benefit most.
Pro-steve 26psi custom Map on single plug ECU, with BSI and two keyfobs for the car itself. - this is mapped for a STANDARD R65 pump and OEM sensor, i have also a map for an R70 and 1800bar sensor that can be included for extra pennies but at your own risk as this was not tested or run on the car.
£350 collected.. you can see pictures of the workmanship in my project thread in my signature..
this is for the following:
Oil lines and drain
turbo (unsure of condition, however these are dirt cheap and it was boosting well till the car got written off and will check before postage)
exhaust manifold
Subframe, with modified bespoke solid gear linkages and main gear linkage arm thingy (that goes between the stick and linkages)
Downpipe with flexi to weld onto mid section (this will need at LEAST a 2.25inch pipe to benefit most.
Pro-steve 26psi custom Map on single plug ECU, with BSI and two keyfobs for the car itself. - this is mapped for a STANDARD R65 pump and OEM sensor, i have also a map for an R70 and 1800bar sensor that can be included for extra pennies but at your own risk as this was not tested or run on the car.
£350 collected.. you can see pictures of the workmanship in my project thread in my signature..
Given the choice between Niall and the sheep. I would choose the sheep!
/Toseland
/Toseland