Wheel bearing help.....

[devils_fuel]

22mm Swan neck spanner is the only 'special' tool I can think of, which you need for undo-ing the top mount nut (in the engine bay!

and why would you need to remove that when changing a wheel bearing? I'm confused!

Basic socket set should do the job with the exception of the hub nut socket which I could post you if needed as long as you look after it and I get it back although they are reasonably cheap off ebay TBH (I think they are 35mm but would have to check tonight as I can't remember)

I will pm about the socket as I will need it, got a torque wrench as well?