18-09-2016, 06:40 PM
(18-09-2016, 06:36 PM)ginge191 Wrote:(18-09-2016, 05:42 PM)Frosty Wrote: The threads WILL go all the way through. It's just with some brakes the bolts don't go all the way into the threads so the threads get dirty and then struggle to get the bolt to go all the way in. Best bet is to run a tap or thread chaser through the threads to clean them up then the bolt will go in fine.
I did this; the actual space for the bolt narrows and is threadless...
I'll try use a chaser and ram/cut it through, see how that goes
usually the case as Frosty says - tap will sort it out. m12x1.5 iirc
project progressing well dude, hows the turbo plate going?