02-06-2016, 09:25 PM
Got back from work at 5pm today so set about starting the pre fcs tidy. Started by fitting the fusebox that finally arrived. Running the ECU, fuel pump and fans all off seperate fuses and its a lot tidier than before. No pictures of the end result but this is the box itself and the fat power cable i made from an amp cable i had lying around
![[Image: IMG_20160602_183057_zpsuc4prxah.jpg]](http://i1184.photobucket.com/albums/z327/srowell3/IMG_20160602_183057_zpsuc4prxah.jpg)
Removed the battery box and found the bottom of it was broken so replaced that. Also replaced the gearbox mount as i had a baker bm item. Found there was a difference in the mounting posts so put the fatter one in.
![[Image: IMG_20160602_174321_zpsbatxdsvo.jpg]](http://i1184.photobucket.com/albums/z327/srowell3/IMG_20160602_174321_zpsbatxdsvo.jpg)
![[Image: IMG_20160602_180024_zpsca1vyo9f.jpg]](http://i1184.photobucket.com/albums/z327/srowell3/IMG_20160602_180024_zpsca1vyo9f.jpg)
![[Image: IMG_20160602_180521_zpsow5vdnlg.jpg]](http://i1184.photobucket.com/albums/z327/srowell3/IMG_20160602_180521_zpsow5vdnlg.jpg)
Finally got the synchrometer out and balanced the bodies. First two were on 7.5 and second pair were on 6.5 Balanced them out a bit so they are all 7.5 now. Went to connect the laptop to check out a few things but dad had upgraded it to windows 10 which of course meant it had lost all the drivers... a job for tomorrow now!
Removed the battery box and found the bottom of it was broken so replaced that. Also replaced the gearbox mount as i had a baker bm item. Found there was a difference in the mounting posts so put the fatter one in.
Finally got the synchrometer out and balanced the bodies. First two were on 7.5 and second pair were on 6.5 Balanced them out a bit so they are all 7.5 now. Went to connect the laptop to check out a few things but dad had upgraded it to windows 10 which of course meant it had lost all the drivers... a job for tomorrow now!