18-04-2016, 03:42 PM
This is the item in question...purchased from a failed 205 project up in cumbria and was painted red..the engine had been sitting for some time so a quick sump off to check for big end bearing play and a freshen up and i could finally try and understand how this was even going to work. The head gasket had already been changed so i gambled on the fact it was done correctly!
After a lot of searching for information about wiring and everything else (didnt come up with much..) and about a year later (when insurance went down), the scaffolding finally came down on the garage and the next day i managed to squeeze the pug in there.
popped the 1.4 out
and wheeled the new lump over to its new home
then came the simple task of making it fit -.-
bit of degreasing work/moving metal out of the way and we are all sorted!
apologiese's for the rotated pics..carnt quite figure that out yet!