12-04-2016, 02:42 PM
Final Parts for the bottom end I think, thrust washers, had been on backorder for about 6 weeks.
![[Image: 26351152196_103b60588d_c.jpg]](https://farm2.staticflickr.com/1659/26351152196_103b60588d_c.jpg)
Made up a bracket to hold the dial gauge (the magnetic stand is Dan's and ion his garage, didn't have it to hand)
![[Image: 26351150786_65c48a3231_c.jpg]](https://farm2.staticflickr.com/1446/26351150786_65c48a3231_c.jpg)
pushed the crank, and got my end float figure
![[Image: 26351150536_096c3d49a7_c.jpg]](https://farm2.staticflickr.com/1649/26351150536_096c3d49a7_c.jpg)
0.13 of a mm, ideal, tolerance is 0.07 to 0.32mm.
Further progress is at a halt till I make/earn more money, as the ehad needs checking over and the seats cutting
Made up a bracket to hold the dial gauge (the magnetic stand is Dan's and ion his garage, didn't have it to hand)
pushed the crank, and got my end float figure
0.13 of a mm, ideal, tolerance is 0.07 to 0.32mm.
Further progress is at a halt till I make/earn more money, as the ehad needs checking over and the seats cutting
need a part number? http://public.servicebox.peugeot.com/ and http://service.citroen.com/ will sort you out.