29-03-2016, 01:14 PM
Remove driveshaft nut, undo bottom ball joint, lever down lower arm. Pop driveshaft down then pop shaft out of box. Use a falt blade screwdriver to pry out the old seal (will be tight) knock in new seal using the old seal as a drift. Make sure its square. Bolt up in reverse order. Top up gearbox oil or do g/box oil change while youre there. Go for a drive
On a break from 306oc for personal reasons. If anyone needs or wants me most of you have my number and or facebook messenger
Thanks for the good times guys n gals. I might be back. Who knows.
Thanks for the good times guys n gals. I might be back. Who knows.