04-04-2012, 02:29 PM
Dan! Wrote:Ah okay, I get you. So theres a locating pin on the cold and the hot side? Pull/hit the housings off, remove locating pin, then is it a case of just putting the housing back on where you want them, or do you have to put the locating pin back in in a different position?
Oh and I think I know this one, but just checking - its fairly important that the oil in is at the top isnt it?
IIRC there is only a pin on the compressor side but may be wrong (it has happened before
) just remove it (pulls out with a pair of pliers no bother) and then re assemble in the correct position.oil in is irrelevant (although it does end up at the top) the important one is that the oil return on the cartridge is at the bottom and as close to vertical when mounted as possible
