01-01-2016, 06:44 PM
Continuing on with the saga I got the head back from RPM which rodger did a cracking job on perfect skim and 3 angle seats.
Got it all down using a genuine mls and a set of arp studs thanks to piggy's group buy awhile ago, then the manifolds etc all fell into place
Couldnt find anymore pics so i must of just steamed through the day
Just need to pick up a few barbs for the inlet manifold, boost guage and lda
At this point i ended up in hospital after going from specialist to specialist for 8 years, needless to say im in much less pain with a 4" cut down my leg then i was before the opp
I bought a DC tig as i'd alway said that i want to learn how to tig, so as soon as i could move enough again i started making some hard boost pipes
not sure if ill use them yet but its mainly practice
Thats all for now folks, i hope to have an update for you come tuesday
Got it all down using a genuine mls and a set of arp studs thanks to piggy's group buy awhile ago, then the manifolds etc all fell into place
Couldnt find anymore pics so i must of just steamed through the day
Just need to pick up a few barbs for the inlet manifold, boost guage and lda
At this point i ended up in hospital after going from specialist to specialist for 8 years, needless to say im in much less pain with a 4" cut down my leg then i was before the opp
I bought a DC tig as i'd alway said that i want to learn how to tig, so as soon as i could move enough again i started making some hard boost pipes
not sure if ill use them yet but its mainly practice
Thats all for now folks, i hope to have an update for you come tuesday