08-11-2015, 10:05 AM
(This post was last modified: 08-11-2015, 10:08 AM by DarkInferno.)
The gear stick isn't centring itself… It’s un-sprung between 3-4 and 5-R, and sprung perfectly normally 1-2 to 3-4. It currently wants to rest anywhere to the right of 3-4
I can put it in all gears, however it has to be worked into 1, sometimes it quite difficult to get in, and sometimes it doesn’t seem to want to move horizontally out of 5-R. (this might be cause it have to go past the 3-4 gate to get to 1-2, and it isn’t trying to pull itself across out of 5-R and I’m a bit shit finding the middle vertically before attempting to move it across)
All of this has happened at once, and suddenly.
I have removed the gear linkage that transfers the horizontal translation, and the gear stick seems completely un-sprung.
Feeling the lever on the gearbox it is sprung in one in one direction and is slack in the other.
As far as I can see all of the linkages are connected and I'm not rubbing or pressing against anything.
Any ideas?
I can put it in all gears, however it has to be worked into 1, sometimes it quite difficult to get in, and sometimes it doesn’t seem to want to move horizontally out of 5-R. (this might be cause it have to go past the 3-4 gate to get to 1-2, and it isn’t trying to pull itself across out of 5-R and I’m a bit shit finding the middle vertically before attempting to move it across)
All of this has happened at once, and suddenly.
I have removed the gear linkage that transfers the horizontal translation, and the gear stick seems completely un-sprung.
Feeling the lever on the gearbox it is sprung in one in one direction and is slack in the other.
As far as I can see all of the linkages are connected and I'm not rubbing or pressing against anything.
Any ideas?