dw10 crank swap 400HP

[zx_volcane]

Little update on this subject after another season of pulling, with the work last winter I ran whole season without any trouble and no bearing damage so my intel could be of use for someone else:

* 2.1l crankshaft from a XUD11
* 86mm bore with billet pistons (if anyone likes to make there own give a jell I send the drawing)
* crank main bearings stock, grinded a groove in the cast of the block and made some extra holes in the top bearing so the bearing groove isn't the only thing spreading the oil.
* big end bearings are GL4558/4 (little more clearance)

Very good of you to come back and update us, glad you've had a good season

Presume you had new conrods made up to go with the 2.1 crank?

Any pics of the pistons ..etc sound absolute pr0n!