306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
How to adjust VNT stop screw ?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to adjust VNT stop screw ?
andyyy Offline
The HDI destroyer!

Posts: 369
Threads: 29
Joined: Jan 2014
Reputation: 0
Location: Reading
Car Model/Spec: 205 1.9 TD
Thanks: 4
Given 2 thank(s) in 2 post(s)
#1
27-09-2015, 07:56 PM
As above 

Read online should wind it out until 2-5 psi is seen at 2000rpm without any load. 

Is this correct / best way to do this. 


Needs to be done as i have replaced the chra. 

Turbo is a gt2052V on a 1.9 XUD
Cherry red 205 XUD VNT - Project thread here http://306oc.co.uk/forum/showthread.php?tid=25522
Find
Reply
Thanks given by:


Messages In This Thread
How to adjust VNT stop screw ? - by andyyy - 27-09-2015, 07:56 PM
RE: How to adjust VNT stop screw ? - by andyyy - 27-09-2015, 08:41 PM
RE: How to adjust VNT stop screw ? - by Piggy - 27-09-2015, 09:20 PM
RE: How to adjust VNT stop screw ? - by andyyy - 28-09-2015, 09:43 AM
RE: How to adjust VNT stop screw ? - by Piggy - 28-09-2015, 10:49 AM
RE: How to adjust VNT stop screw ? - by mr_fish - 28-09-2015, 10:36 AM
RE: How to adjust VNT stop screw ? - by andyyy - 28-09-2015, 11:03 AM
RE: How to adjust VNT stop screw ? - by Piggy - 28-09-2015, 08:29 PM
RE: How to adjust VNT stop screw ? - by andyyy - 29-09-2015, 07:57 AM
RE: How to adjust VNT stop screw ? - by Paul_13 - 28-09-2015, 08:26 PM
RE: How to adjust VNT stop screw ? - by Dum-Dum - 29-09-2015, 03:31 PM
RE: How to adjust VNT stop screw ? - by andyyy - 29-09-2015, 06:40 PM
RE: How to adjust VNT stop screw ? - by andyyy - 29-09-2015, 08:11 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Main Fuel Screw and Idle Speed ally406 6 3,348 28-05-2022, 10:20 AM
Last Post: Martin306
  Bosch pump fuel screw broken Forby 0 1,996 12-03-2019, 06:47 PM
Last Post: Forby
  Radiator bleed screw/ tap vanished, possible better solution simonh 4 2,070 09-05-2017, 10:06 AM
Last Post: simonh

Forum Jump:


Users browsing this thread: 1 Guest(s)