Pressure in cooling system

[Poodle]

And take the front end off, it's 4 bolts and a few plugs, and maybe the 3 lower bumper bolts if you've still got them. Unplug your light looms, not forgetting the beam adjuster plug, fogs and indicators (through that little hole in the inner wing). Then there's a 13mm bolt at the front of the top edge of both wings which fix the slam panel and another 13mm nut each side behind the bumper - those are easiest accessed from underneath. I'd leave the bonnet cable in as it's a sod to feed back through, just pull the whole assembly forwards and lean it to one side. Then you can get the gearbox in mounted on the engine, rather than balancing it on your chest under the car trying to wiggle it into position etc. Means you've got to drain and remove the rad, but looks like you've done that anyway from the pics.