The Landrover Cummins (12v 6BT) Conversion

[darrenjlobb]

Made a bit more progress on this on sunday, put it over the pit and welded up an exhaust for it, something which we have been meaning to get around to for ages!

Started with turbo dump pipe to get down past the motor:





Please ignore the messy wiring, its all temp starter wiring until we wire in the 12/24 crossover relay!

Due to VERY limited space for the exhaust to go in without just going straight underneath and getting detroyed as soon as we took it offroad, we had to route it up around the transmission, which was quite a fiddle, but turned out to fit rather well / managed to keep the front half sold / bolted to engine and gearbox, leaving just the rear section on a flexi / rubber mounts:








Then up through the floor, and once the cab is back on, we will have a stack behind the cab, but for now just a short pipe to direct it away from the landrover:



Took for a test drive in the field and sounds good!!