Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cylinder head faced 0.33mm removed
#1
I have just collected the cylinder head from the machine shop!!

The pressure test was good, they vacuum tested the valves as I freshly ground them back in to there seats and that was all fine.

They skimmed the cylinder head and took 0.33mm off the face, I do not know what the tolerances are for using the started head gasket (which I have already bought). Can somebody advise whether I should be good with a standard head gasket without the valves touching the pistons? Huh

The engine is a XU10J4 from a 1994 306 S16

Thanks!
Reply
Thanks given by:


Messages In This Thread
Cylinder head faced 0.33mm removed - by lpr1981 - 15-05-2015, 10:40 AM
RE: Cylinder head faced 0.33mm removed - by miles - 16-05-2015, 09:57 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  GTI6 cylinder head cully 9 3,137 24-10-2015, 08:19 PM
Last Post: thododd
  Tube found in intake port of cylinder head lpr1981 23 7,511 19-04-2015, 11:11 PM
Last Post: welshpug
  Cylinder head rebuilt, but now sounds like a diesel, please help! rj.stead 6 2,391 14-12-2014, 12:17 PM
Last Post: Dum-Dum

Forum Jump:


Users browsing this thread: 1 Guest(s)