Massey Ferguson F35x

[Jenkosowls]

lift pump that runs off the cam 


cylinder head torqued down with valve terrain inplace



pump cleaned up in degreaser





Flywheel back from blaster so center bearing in place



tractor back from blasters 







more new bits 





tractor in red oxide







thrust bearing in place along with new return springs 





new injector nozzles 



New glow plug 

after much swearing due to lining up the 2 shafts and two clutches the engine was finally mounted 

---

Steering box finally sorted 





Engine in primer 





onto the front spindles new bearings these were then sent off to be reamed 



front carrier and spindles in primer


dash in primer



And then some mighty fine Stone leigh grey 

---

Thanks guys allot of effort over a relatively short time has been put into this

---

wow... thats a bit different but really interesting!

Nice project, what are you doing with the old head?

going for scrap as its to far gone to be worth saving against cost of a new head 

---

injection system in place



inlet on 



breather and water inlet 









Filters in place. (fuel Filter not up side down)



New levelling box