Panel beaters advice
|
Panel beaters advice
|
18-03-2015, 11:07 AM
(This post was last modified: 18-03-2015, 11:08 AM by Nathan1305.)
(18-03-2015, 09:50 AM)THE_Liam Wrote: I was thinking I might get away with a skim of filler after its beaten out or is it too bad for that? If you remove the inner panels to make it easier for them then they could get the bigger dent out easily. And if you're a bit strapped for cash you can ask them to roughly get the shut line straight and just run a small skim of filler to get it perfectly smooth. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Panel beaters advice - by THE_Liam - 17-03-2015, 10:50 PM
RE: Panel beaters advice - by Nathan1305 - 17-03-2015, 11:40 PM
RE: Panel beaters advice - by THE_Liam - 18-03-2015, 06:55 AM
RE: Panel beaters advice - by bashbarnard - 18-03-2015, 07:20 AM
RE: Panel beaters advice - by Choppin - 18-03-2015, 07:25 AM
RE: Panel beaters advice - by welshpug - 18-03-2015, 07:41 AM
RE: Panel beaters advice - by THE_Liam - 18-03-2015, 09:50 AM
RE: Panel beaters advice - by Nathan1305 - 18-03-2015, 11:07 AM
RE: Panel beaters advice - by THE_Liam - 18-03-2015, 11:24 AM
RE: Panel beaters advice - by powerandtorque - 18-03-2015, 11:35 AM
|
