306oc - Peugeot 306 Owners Club & Forum › General › The Couch v
Clarke 160T MIG Wire Feed Issue...

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Clarke 160T MIG Wire Feed Issue...
Danny Wideboy Offline
Living for the MK5 transit

Registered users - Donated
Posts: 1,310
Threads: 47
Joined: Sep 2013
Reputation: 14
Location: Browsing eBay for Turbos.
Car Model/Spec: Ford cougar v6. Mk6 Transit
Thanks: 12
Given 20 thank(s) in 20 post(s)
#3
05-03-2015, 08:00 PM
I had the same problem with my Clarke mig dude.

Need to make sure the new wire you feed in is perfectly straight for a good 2-3 inches, take ALL the curve out of it, it catches on the gas holes, remove the tip (if you havn't already) and try again.
I tried a few times without straightening the wire fully and just wasted a load of it.

HTH.
                                             [Image: 2ljm03k.jpg]
                                                                                      I Don't Have A 306.
Find
Reply
Thanks given by:


Messages In This Thread
Clarke 160T MIG Wire Feed Issue... - by silverzx - 05-03-2015, 11:42 AM
RE: Clarke 160T MIG Wire Feed Issue... - by Danny Wideboy - 05-03-2015, 08:00 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Anyone know a Ryan Bonthrone or Robbie Clarke from Sclotland Ben_w 4 1,671 17-10-2015, 08:19 AM
Last Post: Redordead89
  RIP John Coffey (Michael Clarke Duncan) ginge191 6 2,801 04-09-2012, 04:24 PM
Last Post: Pete

Forum Jump:


Users browsing this thread: 1 Guest(s)