28-02-2015, 09:17 AM
If they were installed properly by the last person the copper washer shouldn't have let any moisture in and should be fine. If you install spark plugs as per the instructions and do not over tighten them, merely tighten them until the washer is crushed then they should also come out.
The problem is previous owners have sometimes done them up to FT spec.
The problem is previous owners have sometimes done them up to FT spec.

This post is an artistic work of fiction and falsehood. Only a fool would take anything posted above as fact.
62k Diablo Phase 1 Gti-6: Project Thread
62k Diablo Phase 1 Gti-6: Project Thread