(26-02-2015, 06:06 PM)joshed Wrote: So i can just fit the new engine straight out of the 306 with the gearbox on into the berlingo, is it best to just cut all all the wires of the 306 so when i come to plug everything in if the switch/ plug doesnt fit i can just rewire it straight up?
also did use the 306 radiator and fan or the berlingos?
What I used or modified was
Berlin go loom
You need the inner part of the short drive shaft of 306
A modified 206 180 clutch had it sitting there but a hdi one might work this is needed to get eco mode off
You will need to find a old pug box to get the push leaver from if you find a early shape Berlin go then the cable also
You have options when power steering you could keep 306 set up personally hate the that tensioner so the Berlin go one can be modified to fit then all power steering pipes fit
Something I haven't Done and don't have a good temp signed becomes 306 sensor resistance is not same and thread different so need to change filter/thermostate housing
Exhaust upgrade
Used 306 rad pipe and berlingo one joined them with pipe and used standard berlingo rad
Used as much berlingo as I could
That's what I can remember for now was planning to do mine over weekend ended up taking over week with all problems and difference I came across wish I had a list like this have fun lol