Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
head gasket
#14
(16-02-2015, 06:08 PM)Toms306 Wrote: Top bleed point is easy by running the engine after the lower ones are clear...  The waterpump pushes it up there lol....
didn't realise you'd owned an xud Tom? ....and that's not right dude
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Reply
Thanks given by:


Messages In This Thread
head gasket - by sb194114 - 15-02-2015, 01:41 PM
RE: head gasket - by Josh_Quant - 15-02-2015, 01:55 PM
RE: head gasket - by sb194114 - 15-02-2015, 01:59 PM
RE: head gasket - by Ruan - 16-02-2015, 04:22 PM
RE: head gasket - by sb194114 - 16-02-2015, 03:39 AM
RE: head gasket - by Mattcheese31 - 16-02-2015, 12:29 PM
RE: head gasket - by sb194114 - 16-02-2015, 12:50 PM
RE: head gasket - by PartyJas - 16-02-2015, 04:35 PM
RE: head gasket - by Mattcheese31 - 16-02-2015, 06:00 PM
RE: head gasket - by sb194114 - 16-02-2015, 04:41 PM
RE: head gasket - by powerandtorque - 16-02-2015, 04:59 PM
RE: head gasket - by sb194114 - 16-02-2015, 05:17 PM
RE: head gasket - by Toms306 - 16-02-2015, 06:08 PM
RE: head gasket - by Mattcheese31 - 16-02-2015, 06:43 PM
RE: head gasket - by sb194114 - 16-02-2015, 06:48 PM
RE: head gasket - by Toms306 - 16-02-2015, 06:49 PM
RE: head gasket - by Mattcheese31 - 16-02-2015, 07:20 PM
RE: head gasket - by Toms306 - 16-02-2015, 07:43 PM
RE: head gasket - by Mattcheese31 - 16-02-2015, 07:54 PM
RE: head gasket - by Toms306 - 16-02-2015, 07:58 PM
RE: head gasket - by Mattcheese31 - 16-02-2015, 08:01 PM
RE: head gasket - by Toms306 - 16-02-2015, 08:22 PM
RE: head gasket - by Mattcheese31 - 16-02-2015, 08:31 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Possible head gasket issues? forbeslongden 3 3,276 16-01-2020, 09:39 PM
Last Post: Mighty306
  Head gasket (again!) Pughawk 1 2,211 08-11-2019, 08:59 AM
Last Post: Mighty306
  Head gasket and Engine rebuilds. weka 2 2,947 15-07-2019, 08:46 AM
Last Post: weka

Forum Jump:


Users browsing this thread: 1 Guest(s)