Rear quarter cards

[Niall]

For the centre pillar, remove the seals around the door and window. Grab the height adjuster for the belt and pull hard till it comes off. Under there is a tiny torx. Remove it and the plastic cover. Now remove the 17mm bolt holding the belt in place and pull the trim off.

Now for the card. Remove the t20 that was behind the pillar trim. Grab the pocket and lift it up and the cover will come off. Remove the t20 behind here. Now, remove the 2 t20s in the boot. These are easy to see. Remove the 17mm bolt for the bottom of the rear seat belt.
Take the rear pillar cover off. There is 2 t20 bolts holding this in and the boot and window seal. Remove the screws and pull. Now, the door card is just clipped in so pull gently and slide out. Job done!