19-01-2015, 07:08 AM
(18-01-2015, 11:25 AM)pugtk Wrote: My spot lights have stopped working in my 205 dturbo after changing my engine and respraying my bay.
Is there any earths in the bay that are linked to the spots(possible bad connection)
Fuse's aren't blown , Does anyone have a wiring diagram?
205 should have the same spot lamps as phase 1 306. Mine stopped working after respray and couldnt work it out.... Put a volt meter to the spade connectors you should be getting around 12v. If your not start with fuse, then relay and check the wires. When mine didnt work the line was getting 12v and the bubls were good and still wouldnt light. There is a small section of wire between car and lamp(about a foot long-har har har) so you can take the bumber off, they are small blue connectors, mine were corroded and stopped the light working... Hope this helps...