19-03-2012, 10:36 AM
Ruan Wrote:I assume its so that you can do 30nm, 60nm, then 270*? I've always just done it so that you do it yourself a bit, then go for 60 then the 180* then a further 90*... So I don't have to use a pissy torque wrench...
Says the guy who continually has cylinder head problems with it stretcgig the studs ROFL....
Its fine doing that though, only reason they do that is to make sure you evenly do it up, just use feel a bit until you get to the min setting of your torque wrench..
And Ruan, I now have two smaller wrenchs, one that goes down to 2nm as well!
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |
![[Image: sigi-2.png]](http://i281.photobucket.com/albums/kk226/darrenjlobb/sigi-2.png)
| #DervMafia |