306oc - Peugeot 306 Owners Club & Forum › General › The Couch v
Has anyone got.....

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Has anyone got.....
Ruan Offline
"Gearbox Side" towards engine 4 lyf

Registered users - Donated
Posts: 5,205
Threads: 91
Joined: Dec 2011
Reputation: 83
Location: Oxfordshire/Cornwall
Car Model/Spec: Moonstone DT/Volvo V50
Thanks: 2
Given 41 thank(s) in 41 post(s)
#12
19-03-2012, 10:31 AM
I assume its so that you can do 30nm, 60nm, then 270*? I've always just done it so that you do it yourself a bit, then go for 60 then the 180* then a further 90*... So I don't have to use a pissy torque wrench...

Says the guy who continually has cylinder head problems with it stretcgig the studs ROFL....
(16-05-2016, 10:45 AM)Toms306 Wrote: Oh I don't care about the stripped threads lol, that's easily solved by hammering the bolt in. Wink
Nanstone GTD5 GT17S - XUD9TE
Volvo V50 D5 R-Design SE Sport - Daily cruise wagon.
Find
Reply
Thanks given by:


Messages In This Thread
Has anyone got..... - by Niall - 17-03-2012, 04:24 PM
Re: Has anyone got..... - by 4WayDiablo - 17-03-2012, 04:26 PM
Re: Has anyone got..... - by Niall - 17-03-2012, 04:27 PM
Re: Has anyone got..... - by 4WayDiablo - 17-03-2012, 04:32 PM
Re: Has anyone got..... - by samass - 17-03-2012, 05:00 PM
Re: Has anyone got..... - by Grant - 18-03-2012, 11:18 PM
Re: Has anyone got..... - by Toby - 18-03-2012, 11:19 PM
Re: Has anyone got..... - by Niall - 18-03-2012, 11:21 PM
Re: Has anyone got..... - by Toby - 18-03-2012, 11:22 PM
Re: Has anyone got..... - by 4WayDiablo - 18-03-2012, 11:27 PM
Re: Has anyone got..... - by Toby - 18-03-2012, 11:43 PM
Re: Has anyone got..... - by Ruan - 19-03-2012, 10:31 AM
Re: Has anyone got..... - by darrenjlobb - 19-03-2012, 10:36 AM
Re: Has anyone got..... - by Niall - 19-03-2012, 11:45 AM
Re: Has anyone got..... - by Ruan - 19-03-2012, 03:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)