25-12-2014, 10:04 PM
The shafts look to be the same thickness. Whilst I'm unlucky with the outer CV''s I'm hopeful that the spiders will swap over (inner or outer) and I can make something from it.
Else it will have to be a cut and weld job - which I'd rather avoid as it'll be more costly.
Brief measure up now I have bits I can work with, the accord looks wider by 30mm than the 306 bay. But it narrows as it goes back. It might be tight but I'm hopeful now I've got this one out
Else it will have to be a cut and weld job - which I'd rather avoid as it'll be more costly.
Brief measure up now I have bits I can work with, the accord looks wider by 30mm than the 306 bay. But it narrows as it goes back. It might be tight but I'm hopeful now I've got this one out