02-12-2014, 09:24 PM
Well, the hub/driveshaft nut is really FT now.
Only thing is, my front wheel is creaking when you rock the top of the wheel and there's a bit of top and bottom movement(wheel bearing style). All joints are new, so is the wheel bearing. The strut top bearing is fine and the pinch bolt at the bottom of the strut is tight and
the bearing was seated fully into the hub.
Both bearing races did come out when I was fitting the bearing into the hub, but it all went back together ok and was nice and smooth and free of any play when tested.
Think the best thing I can do is strip the hub off again and recheck the bearing, then if all appears ok, put it all back together and torque it up.
Only thing is, my front wheel is creaking when you rock the top of the wheel and there's a bit of top and bottom movement(wheel bearing style). All joints are new, so is the wheel bearing. The strut top bearing is fine and the pinch bolt at the bottom of the strut is tight and
the bearing was seated fully into the hub.
Both bearing races did come out when I was fitting the bearing into the hub, but it all went back together ok and was nice and smooth and free of any play when tested.
Think the best thing I can do is strip the hub off again and recheck the bearing, then if all appears ok, put it all back together and torque it up.