16-03-2012, 08:12 PM
Good evening all.
Picking up my 406 inlet fannymold over the weekend, as I'm fitting a FMIC to go with my new turbo.
Simple question really, as I do not know yet which route I'm going to take from the compressor to the 'cooler (I may go round the battery side), is it possible/sensible to use 'flexible' silicon hoses? All the FMIC installs I've seen use rigid ally pipes and silicon joiners.
Ideally I would want to get a few lengths of straight aluminium as it looks like sex in the engine bay, and a couple of metres of flexible hosing.
Yay/nay?
Picking up my 406 inlet fannymold over the weekend, as I'm fitting a FMIC to go with my new turbo.
Simple question really, as I do not know yet which route I'm going to take from the compressor to the 'cooler (I may go round the battery side), is it possible/sensible to use 'flexible' silicon hoses? All the FMIC installs I've seen use rigid ally pipes and silicon joiners.
Ideally I would want to get a few lengths of straight aluminium as it looks like sex in the engine bay, and a couple of metres of flexible hosing.
Yay/nay?
Captain Standard