19-11-2014, 06:18 PM
Not much of an update, but got a little bit done today.
o/s/f wheel bearing replaced, bearing on the top spring seat replaced, just waiting for another front spring, then the leg can be built up and be put back on.
New bottom ball joint and track rod end on the o/s done as well.
Gotta replace the outer cv boot clip as the one on it isn't tight enough and is allowing grease to seep out covering the abs reluctor ring and covering the abs sensor as well.
I'm hoping that once this is all cleaned up again and the boot is tight that my abs light won't come on anymore after a few mins driving.
Got my cambelt kit and a new water pump ready to be fitted, then I've gotta find a set of timing belt covers as mine are missing. Hopefully some on the van in the local scrappy I can get.
[attachment=20185]
o/s/f wheel bearing replaced, bearing on the top spring seat replaced, just waiting for another front spring, then the leg can be built up and be put back on.
New bottom ball joint and track rod end on the o/s done as well.
Gotta replace the outer cv boot clip as the one on it isn't tight enough and is allowing grease to seep out covering the abs reluctor ring and covering the abs sensor as well.
I'm hoping that once this is all cleaned up again and the boot is tight that my abs light won't come on anymore after a few mins driving.
Got my cambelt kit and a new water pump ready to be fitted, then I've gotta find a set of timing belt covers as mine are missing. Hopefully some on the van in the local scrappy I can get.
[attachment=20185]