05-10-2014, 11:18 AM
(05-10-2014, 06:38 AM)Piggy Wrote: Everything sounds ok to me.
Pedal should keep going down, if firm pressure applied, when started due to the servo working
What does it drive like?
If you start the car then switch off and try the pedal...whats it like?
I know it should go down when heavy pressure is applied, but it feels like there's fluid escaping? I checked for leaks, but can't seem to find any? The brakes were perfect before the beam swap, I also lowered the car at the same time while changing the beam. The lines I got made up, used 10mm unions, there not as snug as the original peugeot ones, but tighten up no problem. I am stumped, also what doesn't help is that I'm currently in England working but it finishes next weekend, and the car needs to make a 312 mile trip and would like the brakes fully working :/