01-10-2014, 09:38 PM
The gov can fall out of the levers during assembly, i've had it happen due to what I mentioned with govnor body shaft. Its unlikely that its happened consecutively with you but still possible. This is much more likely to happen if you dont have the splines lined up to start with, pushing the throttle the opposite way without the gov 'locked' into the levers will simply pop it out. Im on about where the govnor slips into the lever, theres a little elongated area on the govnor shaft to allow it to slip in, if you rotate this then the govnor cant pull out unless you 'twist' the govnor. Still sounds like something just isn't back together correctly, or your splines are not fully lined up to act on the levers.
That hole in the collar is in the correct orientation also.
When you say it wont rev, and thus, wont go, do you mean it literally wont start?
That hole in the collar is in the correct orientation also.
When you say it wont rev, and thus, wont go, do you mean it literally wont start?
![[Image: 22f2b6b2-758b-4c1c-96fb-6fa9c6059b13_zpsf306b56b.jpg]](http://i585.photobucket.com/albums/ss299/Ha11elujaz0rs/22f2b6b2-758b-4c1c-96fb-6fa9c6059b13_zpsf306b56b.jpg)