06-08-2014, 05:32 PM
(06-08-2014, 05:17 PM)silverzx Wrote:(06-08-2014, 05:02 PM)darrenjlobb Wrote: God help your xud!!!
Oi - what's that supposed to mean Mr!
Think of the ammount of blowers that could be welded on each week for £500!
Anyway off topic.
To get more on topic, In my mind to do anything "worthwhile" you would need to forge the motor, as i dont see the point in all the effort on these engines just to go low boost / not massive gains, dont get me wrong 250hp is epic, but meh, if your going to the effort, its worth that engine rebuild with rods and pistons imo.
However rosd and pistons asside...if you did the manifold / exhaust / oil lines etc all yourself, its going to cost around 4-500, then the same again for a turbo, and then its just the little bits and pieces like intercooling, mapping / fuel system etc...so its going to go over 1k, but not as HUGELY as some are saying if you are keen yourself....
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |
![[Image: sigi-2.png]](http://i281.photobucket.com/albums/kk226/darrenjlobb/sigi-2.png)
| #DervMafia |