Breaking car - Prices lowered

[Ben]

Heres the pictures of the bad points on the seats (using a 5 pence piece for size comparison)...

Burn in rear lower bench, drivers side, back corner of bench.



Bolster wear


Small bit that has been stitched by previous owner. I've used the seat for over 2 years so the stitchings definatly doing its job.


This holes so small it just looks like another bit of the yellow pattern.


And heres the passenger handle missing the 'underneath' bit of plastic.




Forgot to mention they have leather headrests as I prefered the look and also got fed up of how soft the rallye ones were! I do have the originals though.

Also for those who don't know the bolsters on these seats are closer together than most 306 seats so they hold you tighter.

---

Pictures of the manifold



Where its been filed down


Front face, bit of gasket left on but I'll take it off

---

XUD alternator (70amp), painted silver. Phase 1 type mountings.

---

Boot mat. Haven't got a picture of the floor mats yet, but I'll take some on Sunday.




Let me know if there's any other pictures you'd like, I don't want to just put them all on because its taking ages and I hate computers!