A Street Sleeper is reborn! THE END

[procta]

did a bit more from the snag list of jobs, today.
1st of all, getting my boot lid lamp wired back in place, all I had to do was run the power lead to the boot lid latch and I was way, photos of work.










all powered up

---

next up was wiring in my mgf interior mirror lights,
but I had a fault well I thought it was a fault, with the interior lamp, I had connected the 3 wires the wrong way, its not wired as you would think, with it having two powers and one earth, I thought id check the Haynes manual, but that's a load of shite, told me f*ck all!
Luckly though i had the the original photos from back in the day, off the gta. So after a quick flick through the photo bucket, i found my wiring photo, sadly i didn't take a photo when i removed the lamp wiring as the loom i made dropped to bits, when i removed it so it was sort of guess, but today i have sorted it!
so after a bit of a test with the wiring, I repaired the mgf wiring harness and installed it.





both systems



so that's now in place, and working much, much better!

then another major fault, i have at the min, is the sender gauge wiring for the fuel tank,
well the f*cking ends dropped to bits
so i have had to recycle some old loom and repair it.




the 10 year old plus end that broke off


i will have to get back under there and clean the contacts and check a fuse, as it still not working, Probably due been left out from the car. or its stuck.

i made a start in securing the fuel line in place too, still got the front end to do,
i couldn't access that, as my dad was working on the landy at the time, so i was limited with space!
another fault, is the bastard coolant pipes in the heater matrix, mite need tightening again or something, as some of the water has come through the cab
i did tighten the two again, with a better socket, so we will have to wait and see.
Also i have plan for reworked console too, for the gauges, as the last time it was cable tied in, I am going to mount in place with the original metro bracket, for the tape holder, also the hazard switch is going there too, not on the dash.
i have the old glove box with the lamp, that i will be using as a templet, for the on that's in the car, so i will have that bit lux in too.
still got more to jobs to do, try and sort the front anti role bar, and start to remove tools and other bits and pieces. so that i can give the car a good clean inside!