(21-06-2014, 10:13 AM)Niall Wrote: Im assuming the base of the seat stand is like an X? If so, run a bar of metal parallel to each other over the X, bolt them down then just bolt the car seat runners to the bars you have just made. Half hours work with a bit of drilling and cutting.
Nope, it's like a rectangle with bolt boles on each corner.
Edit - My bad, is is kind of X shaped. What sort of metal would be required for that? I don't have any scrap laying around.(21-06-2014, 10:26 AM)cpikey316_ Wrote: A good thing to do, if you have passenger side fronts, would be to swap the covers to a drivers side one
The drivers side is always the one where the seams go.
Yeah the drivers seat was knackered so I just left it in the car to get scrapped, couldn't let a mint passenger seat go though lol.