06-06-2014, 07:38 AM
basicly as you say!
the two bolts securing the centre shaft bearing dont need to be totaly removed as they will turn out the way once slackened enough,
the bearing might be a bitch to remove from the lower mount you may have to hammer it out,
you wont jack the gearbox high enough to stop oil comming out its easyer to clean the seal area catch what comes out and refill it trough the removed air vent on top of the box or drain and fill, should be 2ltrs of oil in there from empty
drive shaft centre nut is Feckin tight!
M20 nut is 265Nm
M24 nut is 320Nm
the two bolts securing the centre shaft bearing dont need to be totaly removed as they will turn out the way once slackened enough,
the bearing might be a bitch to remove from the lower mount you may have to hammer it out,
you wont jack the gearbox high enough to stop oil comming out its easyer to clean the seal area catch what comes out and refill it trough the removed air vent on top of the box or drain and fill, should be 2ltrs of oil in there from empty
drive shaft centre nut is Feckin tight!
M20 nut is 265Nm
M24 nut is 320Nm