24-04-2014, 08:15 PM
This might be where I've gone wrong, for the measurements i set up 2 dummy dampers from pieces of wood with 300mm gap between bolt holes. Which was 20mm less than what the garage did..
Now even measuring from the arch to the hub its only saying about 5mm lower on the o/s but it seems a lot more than that for some reason.
Is the torsion bar for the o/s the One closer to the front?
Thanks for the reply's
Now even measuring from the arch to the hub its only saying about 5mm lower on the o/s but it seems a lot more than that for some reason.
Is the torsion bar for the o/s the One closer to the front?
Thanks for the reply's