07-04-2014, 02:04 PM
hi fellow 306 ers...........abs light question......
when ign turned on the abs light comes on and stays on for about 3ish seconds, then goes out.....but when engine is "cranked" to start, the abs light comes on....but goes out when key returned to the "run" position and engine running.
Is this normal??
also do you have to remove the brake master cylinder from the servo ( 2 nuts ) and gently move to one side without disturbing the brake lines ( disconnect the fluid sensor wire ) to remove the upper cam belt cover??
reassembled the rear brakes over the weekend, repaired tin shields and painted.........sensors have a magnetic core.......showed 1350ohms each and vac output was over one voltish with a fast hand spin of the hub..............all passing the test data I saw on Friday.......brilliant forum!!
when ign turned on the abs light comes on and stays on for about 3ish seconds, then goes out.....but when engine is "cranked" to start, the abs light comes on....but goes out when key returned to the "run" position and engine running.
Is this normal??
also do you have to remove the brake master cylinder from the servo ( 2 nuts ) and gently move to one side without disturbing the brake lines ( disconnect the fluid sensor wire ) to remove the upper cam belt cover??
reassembled the rear brakes over the weekend, repaired tin shields and painted.........sensors have a magnetic core.......showed 1350ohms each and vac output was over one voltish with a fast hand spin of the hub..............all passing the test data I saw on Friday.......brilliant forum!!