SRowells Diablo 1.8 - Jenvey 45s & OMEX600

[Eeyore]

Hello everyone. Right things finally got done. It took a while and meant staying the night at Toms grans house D: but its all done now. The GTI6 box fitted on eventually and we got everything plugged back in. A few of the brackets to support pipes and wiring dont fit and the lower flywheel cover also doesnt fit as normally the gti6 sump covers up the hole. On the standard 306 there is a flat spot where the reversing cable goes through. I had to drill this out and it came out probably in the wrong place, but the footwell was good enough! Didnt get the bike lever fitted as the cable end wouldnt fit the lever. Reverse has to be activated by pulling the wire :/

First we started outside in the drive...


Box fitted...



Fly wheel cover didnt fit.


Reverse cable hole drilled...


Tom working it...


and the best picture!


all finished and ready to go!