28-03-2014, 08:52 AM
So DeeTurbo helped (well mainly done himself) swap my rear beam over to a known good one last weekend and the car now sits square (ish!) which I'm enjoying.
However one of the ABS sensors on the new beam isn't playing ball. I knew one had a crack in the casing but we checked the resistance and it seemed fine before it went on.
Will plugging the car in to PP indicate what sensor is playing up?
What is the best way of removing the sensors? As these seem pretty f*cking solid!
However one of the ABS sensors on the new beam isn't playing ball. I knew one had a crack in the casing but we checked the resistance and it seemed fine before it went on.
Will plugging the car in to PP indicate what sensor is playing up?
What is the best way of removing the sensors? As these seem pretty f*cking solid!
Disclaimer: The above is not to be taken to heart and is probably a joke, grow up you big girl.
![[Image: Sig500x130.png]](http://i430.photobucket.com/albums/qq25/chris_rx71/Sig500x130.png)