The Bavarian

[tenwierdufos]

Have you had the maps apart yet to see if you can see a pump voltage table... I'll bet you they're rediculously simple once you've figured out where a few maps are...

Nah i havent, not sure how to go about it to be honest, need an EPROM programmer, UV eraser and some software that can translate all the hex garbage into something usable.

From what i have seen rather that the maps showing as a pump voltage they are an injection request in mg per injection.

The highest they will accept is 51, however there seem to be some tricks to multiply that.

Was reading some chaps website which had a bit of detail, he was working on his Omega which had the M51D25 in it.




Coilovers are on!

First attempt at guessing where to set them resulted in a low entry jack that was stuck underneath the car, so it had to go up somewhat from that!




And then how it actually sits now.