20-01-2014, 09:36 AM
(This post was last modified: 20-01-2014, 09:37 AM by azzaboi306.)
(20-01-2014, 09:03 AM)RetroPug Wrote: You'll need to drill holes in the splitter (it's made of hard rubber so not a problem, and cut the ends off to make it the right length.
Then you just bolt it to the bumper using the holes in the underside of the bumper.
Yeah I know about fitting it juat wondered if its the right size, but thanks
(20-01-2014, 09:15 AM)PE02KHG Wrote: Its quite square and i doubt it would look great but the corrado vr6 splitter is 90mm
Haha awesome thanks, I'll have a look