30-12-2013, 11:16 PM
raise front of vehicle and support
drain gearbox
remove from wheels
remove driveshafts - note two 11mm nuts holding two retain bolts on engine lower mount which hold one shaft in
remove all the crap around the gearbox, wiring, clutch cable, starter etc
undo the clutch release arm bolt and remove clutch release arm
support engine
undo gearbox mount and remove mount supports
support gearbox - handy friend witha jack
undo all gearbox bolts between bell housing and engine block
remove gearbox
remove clutch
clean flywheel surface
fit new clutch - use alignment tool to centralise
refit gearbox ensuring clutch arm slots onto clutch release bearing
now put it all back together, fill up with fresh oil and have a cuppa T
(worthwhile attaching the clutch arm and cable early on to check it all has aligned ok)
drain gearbox
remove from wheels
remove driveshafts - note two 11mm nuts holding two retain bolts on engine lower mount which hold one shaft in
remove all the crap around the gearbox, wiring, clutch cable, starter etc
undo the clutch release arm bolt and remove clutch release arm
support engine
undo gearbox mount and remove mount supports
support gearbox - handy friend witha jack
undo all gearbox bolts between bell housing and engine block
remove gearbox
remove clutch
clean flywheel surface
fit new clutch - use alignment tool to centralise
refit gearbox ensuring clutch arm slots onto clutch release bearing
now put it all back together, fill up with fresh oil and have a cuppa T
(worthwhile attaching the clutch arm and cable early on to check it all has aligned ok)
Wishes for more power...