30-12-2013, 08:09 PM
(30-12-2013, 08:06 PM)Niall Wrote: Looks good mate. id be tempted to get that window motor covered over. You want the whole lot covered over to hide any rattles lol
Yeh I was waiting for comments about how I had dampened the door. Wasn't entirely sure how much to put on. There inside of the door is done front to back and top to bottom best I could. The panel you can see I just did thrbflat bits. Ill do the other door and see how much ivrbgot left over and then add the rest.
Note the silly double cross overs. I put them in the only place they would fit and had to remove the polystyrene from the door card. The tweeter crossover is adjustable with 0 +3 and +6 db. Luckily you can pull the end of the door card away enough to get a hand in and adjust them without completely removing the speakers etc.
Also for the record its all done properly with crimps and bullets. No bare wires here going into amps and cross over here. Unfortunately both my new soldering iron and old one both don't work really annoying so everything is crimped. Not how I wanted to do it in a few places but it will make sense if I ever swap cars.