30-11-2013, 05:52 PM
(This post was last modified: 30-11-2013, 05:53 PM by Rippthrough.)
(25-11-2013, 07:22 PM)welshpug Wrote: I doubt they would be large enough bore, I would get a load compensator fitted if you wanted the big drum setup.
I think the bore is the same but the width is different, although it's been a while since I was tinkering with 'em. And yes, the early cars have pressure limiters in the rear cylinders themselves.
Custom roll cages/shiny suspension bits/general fabrication work undertaken, PM me.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.