26-11-2013, 05:35 PM
I just bought the last one for £2.29 or something.
Just trying to think how I'm going to stop it getting sucked into the inlet..
Initial thought is zip tie it through a silicone join.. But that'll boost leak to f**k!
Second thought is put it pre FMIC and it'll have a job getting through there, but it's pre-FMIC (fairly useless) and the probe will probably fail to reach the dash/unit!
Third thought is to buy a tap that I can drill into the inlet manifold, place the probe in it and cover it in black silicone to seal it in place.
Any advice/thoughts?
Just trying to think how I'm going to stop it getting sucked into the inlet..
Initial thought is zip tie it through a silicone join.. But that'll boost leak to f**k!
Second thought is put it pre FMIC and it'll have a job getting through there, but it's pre-FMIC (fairly useless) and the probe will probably fail to reach the dash/unit!
Third thought is to buy a tap that I can drill into the inlet manifold, place the probe in it and cover it in black silicone to seal it in place.
Any advice/thoughts?
![[Image: signature.png]](http://s22.postimg.org/cgh3ss11t/signature.png)
